Relearn Code: LEX-2

Relearn Procedures:

1. Inflate all tires to pressure indicated on tire placard.
2. Turn ignition to ON position (engine off).
3. Hold down tire pressure warning reset switch until Pressure Initial indicator is displayed.
4. Vehicle will have to be driven at speeds above 19mph to complete initialization.

*A properly formatted scan tool is required to learn new sensor IDs when replacing sensors.

**Vehicle may be equipped with a Main/2nd switch located at base of driver side knee bolster, underneath glove box, or inside glove box. Sensor IDs must be written to the position the switch is pressed.